2.4(top 7%)
Impact Factor
2.5(top 7%)
extended IF
43(top 9%)
H-Index
1.6K
authors
3.2K
papers
27K
citations
1.5K
citing journals
11.7K
citing authors

Most Cited Articles of Metals and Materials International

TitleYearCitations
Design of Bulk metallic glasses with high glass forming ability and enhancement of plasticity in metallic glass matrix composites: A review2005118
Oxygen effects on the mechanical properties and lattice strain of Ti and Ti-6Al-4V201197
On the transitions of deformation modes of fully austenitic steels at room temperature201094
Prediction of grain size and yield strength of Mg-7Sn-1Al-1Zn alloys extruded at various temperatures and speeds201488
Enhancement of the glass forming ability of Cu−Zr−Al alloys by Ag addition200486
Microstructure, electrical conductivity and hardness of multilayer graphene/Copper nanocomposites synthesized by flake powder metallurgy201583
Formation of amorphous phase in the binary Cu−Zr alloy system200675
Optimizing friction stir welding parameters to maximize tensile strength of AA2219 aluminum alloy joints200968
Bioleaching: A microbial process of metal recovery; A review200568
Research and Development in Magnesium Alloys for Industrial and Biomedical Applications: A Review202068
The effect of yttrium oxide on the sintering behavior and hardness of tungsten200665
Mechanical properties of metals for biomedical applications using powder metallurgy process: A review200665
Microstructure and mechanical properties of friction stir welded and laser welded high entropy alloy CrMnFeCoNi201863
Purification of metallurgical silicon using iron as impurity getter, part II: Extent of silicon purification201162
Effects of annealing conditions on microstructure and mechanical properties of low carbon, manganese transformation-induced plasticity steel200961
Rapid sintering of ultra fine WC and WC-Co hard materials by high-frequency induction heated sintering and their mechanical properties200760
Amorphous phase formation in a Ni−Zr−Al−Y alloy system200459
Processing and mechanical properties of porous silica-bonded silicon carbide ceramics200559
The correlation between dendritic microstructure and mechanical properties of directionally solidified hypoeutectic Al-Ni alloys201055
Zinc phosphate conversion coatings on magnesium alloys: A review201354
Characterization of microstructure of HAZs in as-welded and service condition of P91 pipe weldments201753
Effect of Ti addition on tensile properties of Cu-Ni-Si alloys201153
Prediction of dynamic recrystallization kinetics and grain size for 410 martensitic stainless steel during hot deformation201053
Temperature effect on twin formation kinetics and deformation behavior of Fe-18Mn-0.6C TWIP steel201450
Effect of Ca addition on microstructure of twin-roll cast AZ31 Mg alloy200950