Review of the mechanical properties of carbon nanofiber/polymer composites | Composites Part A: Applied Science and Manufacturing | 2011 | 306 |
Electrical and electromagnetic interference shielding properties of flow-induced oriented carbon nanotubes in polycarbonate | Carbon | 2011 | 302 |
Highly electrically conductive and high performance EMI shielding nanowire/polymer nanocomposites by miscible mixing and precipitation | Journal of Materials Chemistry | 2011 | 216 |
Metal Oxide Nanoparticles for Asphaltene Adsorption and Oxidation | Energy & Fuels | 2011 | 212 |
Copper nanowire/polystyrene nanocomposites: Lower percolation threshold and higher EMI shielding | Composites Part A: Applied Science and Manufacturing | 2011 | 171 |
Application of Nanotechnology for Heavy Oil Upgrading: Catalytic Steam Gasification/Cracking of Asphaltenes | Energy & Fuels | 2011 | 155 |
Effect of surface acidity and basicity of aluminas on asphaltene adsorption and oxidation | Journal of Colloid and Interface Science | 2011 | 104 |
Comparative oxidation of adsorbed asphaltenes onto transition metal oxide nanoparticles | Colloids and Surfaces A: Physicochemical and Engineering Aspects | 2011 | 101 |
Reaction kinetics and mass transfer studies of biomass char gasification with CO2 | Chemical Engineering Science | 2011 | 94 |
Relative permeability of CBM reservoirs: Controls on curve shape | International Journal of Coal Geology | 2011 | 84 |
Biomass to hydrogen via catalytic steam reforming of bio-oil over Ni-supported alumina catalysts | Fuel Processing Technology | 2011 | 82 |
The impact of geochemistry on convective mixing in a gravitationally unstable diffusive boundary layer in porous media: CO2 storage in saline aquifers | Journal of Fluid Mechanics | 2011 | 81 |
Effect of the Particle Size on Asphaltene Adsorption and Catalytic Oxidation onto Alumina Particles | Energy & Fuels | 2011 | 76 |
Production of hydrogen by steam reforming of bio-oil over Ni/Al2O3 catalysts: Effect of addition of promoter and preparation procedure | Fuel Processing Technology | 2011 | 69 |
Land uplift due to subsurface fluid injection | Journal of Geodynamics | 2011 | 64 |
Sedimentology and stratigraphic architecture of a point bar deposit, Lower Cretaceous McMurray Formation, Alberta, Canada | Bullentin of Canadian Petroleum Geology | 2011 | 64 |
Matrix–fracture transfer shape factor for modeling flow of a compressible fluid in dual-porosity media | Advances in Water Resources | 2011 | 58 |
Modeling the phase behavior of heavy oil and solvent mixtures | Fluid Phase Equilibria | 2011 | 58 |
Kinetic Analysis of CO2 Gasification of Petroleum Coke at High Pressures | Energy & Fuels | 2011 | 56 |
Adjustment of drag coefficient correlations in three dimensional CFD simulation of gas–solid bubbling fluidized bed | Advances in Engineering Software | 2011 | 56 |
Alkaline hydrothermal conversion of cellulose to bio-oil: influence of alkalinity on reaction pathway change | Bioresource Technology | 2011 | 53 |
Bio-oil from Sawdust: Effect of Operating Parameters on the Yield and Quality of Pyrolysis Products | Energy & Fuels | 2011 | 53 |
Experimental investigation of incipient equilibrium conditions for the formation of semi-clathrate hydrates from quaternary mixtures of (CO2+ N2+ TBAB + H2O) | Journal of Chemical Thermodynamics | 2011 | 52 |
Experimental Measurements of the Thermodynamic Equilibrium Conditions of Tetra-n-butylammonium Bromide Semiclathrates Formed from Synthetic Landfill Gases | Journal of Chemical & Engineering Data | 2011 | 51 |
Life cycle greenhouse gas emissions of current oil sands technologies: GHOST model development and illustrative application | Environmental Science & Technology | 2011 | 50 |